top of page


The Engineering team designs equipment according to the applicable codes and standards:

  • European Pressure Equipment Directive (PED 2014/64 / EU)


  • EN 13445 / CODAP / AD2000

  • TEMA

  • Stability calculation including wind, earthquake, snow, etc.



These calculations are carried out using dedicated software and checked if necessary by approved organizations.

CrolleAgency_Pommee_Bureaux (6 sur 29).jpg


Our team of qualified welders manufactures equipment according to the defined welding procedures.

We weld carbon steel, stainless steel and nickel alloys.

Equipment finishing is applied according to the needs of the application:

  • Primary paint , Epoxy, PU, ​​...

  • Pickling / passivation

  • Mechanical polishing and electro polishing

  • Galvanization

  • Nickel plating


Quality Control

The non-destructive tests are carried out  internally or by approved external organizations, according to the needs of the project:

  • PMI (Positive Material Identification)

  • Inspection of welds by radiography , penetrant testing , ultrasound, etc.

  • Endoscopic inspection

  • Surface roughness measurement

  • Measurement of ferrite content and sharpy tests for cryogenic applications.

  • Vacuum test and helium micro-leak detection

In addition, all our equipment undergoes a final hydraulic test or FAT (Factory Acceptance Test) before shipment.

bottom of page